Below details mentioned are event details listed on a per Category basis.
|
Severity Level |
Policy ID |
Description |
Cause |
Resolution |
|
5 |
NETWORK.X1.1 |
NETWORK.X1.1: Maximum Bandwidth ${WAN_LIMIT} to Cloud Reached |
NETWORK.X1.1: Alert when bandwidth to cloud is saturating limits |
NETWORK.X1.1: node may be consistently hitting bandwidth limits to the cloud. If current workload is expected to be normal, bandwidth limits/actual bandwidth may need to be increased. |
|
3 |
NETWORK.X1.2 |
NETWORK.X1.2: Maximum Bandwidth ${WAN_LIMIT} from Cloud is reached |
NETWORK.X1.2: Alert when bandwidth from cloud is saturating limits |
NETWORK.X1.2: node may be consistently hitting bandwidth limits from the cloud. If current workload is expected to be normal, bandwidth limits/actual bandwidth may need to be increased. |
|
4 |
NETWORK.X1.3 |
NETWORK.X1.3: Throughput throttling rate:${THRT_RATE} |
NETWORK.X1.3: Alert when user network throughput is being rate limited |
NETWORK.X1.3: The node may be running out of space for new writes. Reduce new writes to the node. If the issue still persists, contact Panzura Technical Support. |
|
10 |
NETWORK.X1.4 |
NETWORK.X1.4: ${RESULTS} |
NETWORK.X1.4: Alert when the cloud connection is administratively blocked |
NETWORK.X1.4: Administrative control is managed on the WebUI at System Configuration - Diagnostic Tools - Command Type : block-mirror-cloud with parameter: show. |
|
10 |
NETWORK.X1.5 |
NETWORK.X1.5: ${RESULTS} |
NETWORK.X1.5: Alert when the cloud connection is administratively blocked |
NETWORK.X1.5: Administrative control is managed on the WebUI at System Configuration - Diagnostic Tools - Command Type : block-mirror-cloud with parameter: show. |
|
4 |
NETWORK.X1.6 |
NETWORK.X1.6: Excessive TCP retries or disconnects |
NETWORK.X1.6: Alert when there is an excessive amount of TCP retries or sys disconnects greater than 2 percent |
NETWORK.X1.6: Check network links for bad cabling, bad NICs, and TCP offloading at the source or destination. If the issue still persists, contact Panzura Technical Support. |
|
8 |
NETWORK.L1.2 |
-OSE-NETWORK.L1.2: Interface $0 $1 |
NETWORK.L1.2: Alert when Network Interfaces have up/down events. |
NETWORK.L1.2: Check network links for bad cabling, bad NICs, or intermediary switches. If the issue still persists, contact Panzura Technical Support. |